Procedure

In this tab you have the possibility to send different packets via a procedure.

  1. The individual UDP packets are stored in folders, which can selected here.
  2. All UDP packets which are stored under the selected folder.
  3. To add the selected packet to the procedure (4).
  4. Here is the procedure shown which is executed in order from top to bottom.
  5. To delete the selected procedure item.
  6. To move the selected procedure item down.
  7. To move the selected procedure item up.

To interact with the procedure there are some special packets under the folder "DefaultPackets".

For now there are the following "DefaultPackages" available:

Packet Value 1 Value 2
Delay How long the procedure shall be wait until he goes to the next item. -
GoTo The procedure shall jump to the here defined Nr. -
GoToAfter The procedure shall jump to the here defined Nr. The procedure jumps to the defined item (Value 1) after the her defined executions.
WaitForPacket The procedure waits until this defined packet is received -


Here a short example:

  1. Nr. 0 = Send UDP packet.
  2. Nr. 1 = Wait for 1 second.
  3. Nr. 2 = Decrease Value 2.
  4. Nr. 3 = Go to Nr. 0.
  5. Nr. 0 = Send UDP packet.
  6. Nr. 1 = Wait for 1 second.
  7. Nr. 2 = Go to Nr. 4.
  8. Nr. 4 = Wait for 100ms and end.